HP ML110 G7 and VT-d DirectPath I/O Configuration and VMware FT

I’ve had quiet a few questions over the past days about the HP ProLiant ML110 G7. And here are some screenshots aboutabout using Intel VT-d or DirectPath I/O and VMware FT.

To use the Intel VT-d DirectPath I/O you need to make sure that Intel VT-d is enabled in the BIOS of the ML110 G7. Then you can assign any non used PCIe card that supports it for DirectPath I/O configuration. Assigning a PCIe device for DirectPath I/O configuration requires the ESXi to reboot.

ML110G7 and VT-d DirectPath IO Configuration

Here is a close up on the SmartArray P212 select for Passthrough mode.

SmartArray P212 in Passthrough mode

The second question I got a few time is can I also use VMware FT. Yes you can, theIntel E3 Xeon CPU are recent enough to support the Lockstep process of VMware FT. Here is a screenshot of my vShield Manager appliance running with VMware FT protection between two HP Proliant ML110 G7.

VMware FT on ML110G7

 

So Just to resume, the HP ProliantML110 G7 is an awesome system for ESXi 5.0 and allows you to use VMware HA & DRS, VMware FT, DirecPath I/O mode (VT-d), VMware Distributed Power Management via the HP iLO3 module.